TOSHIBA hfe toshiba rd-x2-u service en free download

File name hfe_toshiba_rd-x2-u_service_en.pdf

FILE NO. 810-200220 SERVICE MANUAL HDD/DVD VIDEO RECORDER RD-X2U Oct., 2002 5 LASER BEAM CAUTION LABEL When the power supply is being turned on, you may not remove this laser beam caution label. If it removes, radiation of a laser may be received. PREPARATION OF SERVICING Pickup Head consists of a laser diode that is very susceptible to external static electricity. Although it operates properly after replacement, if it was subject to electrostatic discharge during replacement, its life might be shortened. When replacing, use a conductive mat, soldering iron with ground wire, etc. to protect the laser diode from damage by static electricity. And also, the LSI and IC are same as above. Ground conductive wrist strap for body. Soldering iron with ground wire or ceramic type 1M 9 Conductive mat The ground resistance between the ground line and the ground is less than 10 9 . SAFETY NOTICE SAFETY PRECAUTIONS LEAKAGE CURRENT CHECK Plug the AC line cord directly into a 120V AC outlet (do Measure the AC voltage across the 1500 W resistor. not use an isolation transformer for this check). Use an The test must be conducted with the AC switch on and AC voltmeter, having 5000 W per volt or more sensitivity. then repeated with the AC switch off. The AC voltage Connect a 1500 W 10 W resistor, paralleled by a 0.15 mF indicated by the meter may not exceed 0.3 V. A reading 150V AC capacitor between a known good earth ground exceeding 0.3 V indicates that a dangerous potential (water pipe, conduit, etc.) and all exposed metal parts of exists, the fault must be located and corrected. cabinet (antennas, handle bracket, metal cabinet Repeat the above test with the DVD VIDEO RECORDER screwheads, metal overlays, control shafts, etc.). power plug reversed. NEVER RETURN A DVD VIDEO PLAYER TO THE CUSTOMER WITHOUT TAKING NECESSARY CORRECTIVE ACTION. READING SHOULD NOT EXCEED 0.3V AC VOLTMETER DVD VIDEO PLAYER (5000 9 per volt